Agricultural Engineering Set 32

Other topics

Learning Mode Previous Next
On This Page

This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 32

Q1 | The capacity of thermal dryer depends on the
Q2 | An angular distance of the sunrays north (or south) of the equator is
Q3 | A wooden pitman is generally used in
Q4 | The optimum moisture content (wb) for paddy harvesting is
Q5 | For air-drying the recommended normal air temperature is
Q6 | The speed of hammer tip of a Rietz mill varies from
Q7 | Denudation rate is expressed in the unit of
Q8 | The cutter bar used in cutting unit of combine is
Q9 | Coefficient of traction is defined as
Q10 | A group of solar cell is
Q11 | The capacity of tractor-operated vertical conveyer reaper is about
Q12 | Contour trenching is done mainly in
Q13 | Thermal conductivity of air is
Q14 | The power produced from a wind speed 6.4 to 37 km ph by windmill varies from
Q15 | USLE was developed for
Q16 | The lowest temperature at which fuel begins to crystallize is
Q17 | Two bullocks weighing 750 Kg each are pulling an implement with speed of 2 km/h. The hp that required pulling an implenment is
Q18 | Maximum torque in a tractor is generated at
Q19 | A type of cylinders used on power wheat threshers is
Q20 | A vertical between the projection of the sun's rays on the horizontal plane and direction of sun's rays is
Q21 | Wind erosion is more in
Q22 | A steam engine is an
Q23 | Gravity test is done by using the
Q24 | The planters are suitable for maintaining distance between
Q25 | The primary purpose of ring expander is to
Previous Next