Agricultural Engineering Set 21

On This Page

This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 21

Q1 | Cold spark plug is used in
  • IC engine
  • CI engine
  • Light duty engine
  • Heavy duty engine
Q2 | The percent of edible oil in rice bran is about
  • 10?11
  • 14?16
  • 18-20
  • 11?14
Q3 | Viscosity of oil expressed at two temperatures is
  • ?18?C and 99?C
  • ?20?C and 100?C
  • ?20?C and 120?C
  • ?18?C and 150?C
Q4 | The rising limb of a hydrograph is also known as
  • S-curve
  • Concentration curve
  • Flow mass curve
  • Double mass curve
Q5 | The indicated horsepower of an engine was measured by
  • Dynamometer
  • Tachometer
  • Indicator
  • None of these
Q6 | A geological formation which is neither porous nor permeable and there are no interconnected openings hence it cannot transmit water is called
  • Perch aquifer
  • Aquiclude
  • Aquifuge
  • Aquitard
Q7 | In angle bar cylinder type thresher, the clearance between cylinder and concave unit at the end
  • 1-3 mm
  • 3-6 mm
  • 5-8 mm
  • 6-9 mm
Q8 | A seed drill of size 10 x 20 cm has seed drop in one revolution is 40 gram. The area covered by seed drill in one revolution 9.42 m2. The seed rate (kg/h) is
  • 2.2 K
  • 22 K
  • 1.36 K
  • 136 K
Q9 | ML-light servvice, MM. medium service and MS- severe service are service classes for the
  • SI engines
  • IC engines
  • Steam engines
  • All are correct
Q10 | A device that is used to adjust the lateral movement of plough is
  • Vertical suction
  • Vertical clevis
  • Horizontal suction
  • Horizontal clevis
Q11 | The variation in engine speed is observed at full load and no load is approximate
  • 100 rpm
  • 150 rpm
  • 200 rpm
  • 250 rpm
Q12 | The specific gravity of fuel is measured by
  • Hygrometer
  • Thermometer
  • Hydrometer
  • All are correct
Q13 | In disc plough, the angle at which the plane of cutting edge of disc is inclined to the vertical line is
  • Disc angle
  • Tilt angle
  • Gang angle
  • None of above
Q14 | Melting point of aluminium is about
  • 100?C
  • 500?C
  • 660?C
  • 800?C
Q15 | The arrangements of valves used in the engine may be
  • I-Head type
  • T-head type
  • L-head type
  • All are correct
Q16 | Primary coil has
  • Small number of turns of heavy wire
  • More number of turns of thin wire
  • Both (a) & (b)
  • None of these
Q17 | The device that permits one of the rear wheels of tractor to rotate faster than the other at the turning is called
  • Power train
  • Clutch
  • Differential lock
  • None of these
Q18 | If the pH range of slurry is between 4 and 6 the slurry is
  • Acidic
  • Alkaline
  • Neutral
  • None of these
Q19 | A hydrograph produced by a continuous effective rainfall at a constant rate for an infinite period is known as
  • S-hydrograph
  • Drect run off hydrograph
  • Hyetograph
  • Double mass curve
Q20 | The material that is left by te harvesting machine in row is
  • Swath
  • Stubble
  • Straw
  • All are correct
Q21 | Gully erosion is the advance stage of
  • Splash erosion
  • Sheet erosion
  • Rill erosion
  • All are correct
Q22 | Cetane rating of commercial diesel fuel is
  • 30-60
  • 30-70
  • 30-65
  • 30-80
Q23 | Positive plate of lead-acid battery is made of
  • PbO2
  • Pb
  • PbSO4
  • H2SO4
Q24 | F-type valves are used in engines has
  • Pre-combustion chamber
  • External combustion chamber
  • Don't have combustion chamber
  • Both (a) & (b)
Q25 | The quantity of gas produced by one kg of dry dung is about
  • 0.156 m3
  • 0.160 m3
  • 0.175 m3
  • 0.186 m3