On This Page
This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 42
Q1 | Tillage system, which is suitable for dry land agriculture, is
- Till plant system
- Zero tillage
- Minimum tillage
- All are correct
Q2 | The drying process involves
- Heat transfer
- Mass transfer
- Heat and mass transfer
- None of these
Q3 | The IHP of the engine indica+ es
- Power on piston
- Power on flywheel
- Power on drawbar
- Loss of power
Q4 | Say bolt viscometer is used for
- Flash point testq
- Viscosity test
- Pour point test
- Colour and carbon residue
Q5 | Centre of gravity of tractor is determined by
- Suspension method
- Balancing method
- Weighing method
- All are correct
Q6 | Darcy's law is applicable when Reynolds number is
- Equal to 1
- Less than 1
- More than 1
- Less than 2
Q7 | Air temperature in solar drying in comparison to sun drying is
- Equal
- Low
- High
- None of these
Q8 | Ignition timing depends on
- Engine speed
- Compression ratio
- Valve timing
- All are correct
Q9 | The expected annual use of planter is
- 800 hours
- 1000 hours
- 1100 hour
- 1700 hours
Q10 | Disc angle of standard disc plough varies from
- 15-25?
- 25-35?
- 35-42?
- 4-45?
Q11 | In pounding method, rice recovery ranges from
- 55-60%
- 60-65%
- 65-68%
- 68-70%
Q12 | Edge cell and edge drop plates of metering mechanism are well suited for planting
- Large seeds and flat seed
- Large and round seed
- Small seeds and flat seeds
- Small arnd round seed
Q13 | Ballasting is done by
- Water
- Oil
- Calcium chloride
- All are correct
Q14 | The pump used in airplane sprayers
- Dentrifugal and gear pump
- Gear and Diaphragm pump
- Diaphragm and centrifugal pump
- Plunger and centrifugal pump
Q15 | Water that holds highly to the surface of soil particles by adsorption force is
- Hygroscopic water
- Capillary water
- Gravitational water
- None of these
Q16 | The spike of MB plough is expressed in
- Width of cut
- Depth of cut
- Length of share
- None of these
Q17 | The fuel injected through a nozzle of carburetor is at a pressure of
- 10 to 45 kg/cm2
- 50 to 120 kg/cm2
- 126 to 175 kg/cm2
- 100 to 300 kg/cm2
Q18 | In general tractor, frequency should be
- 3.10 Hz
- 3.12 Hz
- 5.15 Hz
- 5.20 Hz
Q19 | Soil Erodibility is a
- Dynamic process
- Static process
- Both (a) and (b)
- None of these
Q20 | The cutting width of small size propelled combine ranges from
- 1.5-2.1 m
- 1.5-2.25 m
- 1.5-2.5 m
- 1.5-3.0 m
Q21 | Plough share is made up of
- Mild steel
- Cast iron
- Gun metal
- None of these
Q22 | In radiator, hot water flows at the
- Top
- Bottom
- Middle
- None of these
Q23 | The cylinder speed of rotary type thresher is
- 200 rpm
- 300 rpm
- 400 rpm
- 500 rpm
Q24 | Heat value of the gas produced in gas fire is about
- 950-1200 kcal/m3
- 1000-1300 kcal/m3
- 1200-1500 kcal/m3
- 1500-1800 kcal/m3
Q25 | Fluctuation of engine speed during a cycle depends upon
- Crankshaft
- Governor
- Mass of flywheel
- All are correct