Agricultural Engineering Set 7

On This Page

This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 7

Q1 | The period petween start of injection and ignition is called
  • Ignition period
  • Injection time
  • Ignition delay
  • All are correct
Q2 | In a windmill, tip speed ratio increases with
  • Increase of number of blades
  • Decrease of number of blades
  • Independent of blade number
  • None of these
Q3 | For engine bearings, a type of lubrication system adopted is
  • Gravity feed lubrication
  • Wick lubrication
  • Ring lubrication
  • All are correct
Q4 | The governor is used on tractor engine is called
  • Constant speed governor
  • Variable speed governor
  • Both (a) & (b)
  • None of these
Q5 | Single plate clutch is also known as
  • Single disk clutch
  • Double disk clutch
  • Dog clutch
  • All are correct
Q6 | In four-stroke cycle engine, one power stroke is obtained after every
  • Half revolution of crankshaft
  • One revolution of crankshaft
  • Two revolution of crankshaft
  • Three revolution of crankshaft
Q7 | In hydraulic sprayers, the degree of atomization is primarily a function of
  • Air velocity
  • Size of nozzle
  • Size and shape of atomizer
  • Liquid pressure and the nozzle characteristics
Q8 | The shelling of paddy in rubber roll sheller is due to
  • Rubbing
  • Crushing
  • Shearing
  • All are correct
Q9 | In comparison to raw rice is parboiled rice rich in
  • Protein
  • Vitamin
  • Minerals
  • All are correct
Q10 | A subsoiler is used to break a hard pan of soil upto a depth of
  • 15 cm
  • 20 cm
  • 30 cm
  • 100 cm
Q11 | In spark ignition engines fuel is ignited by
  • Battery ignition system
  • Magneto ignition system
  • Both (a) & (b)
  • None of these
Q12 | The useful working hours of mounted type combine is
  • 1000
  • 1200
  • 1800
  • 2000
Q13 | At steep slope the depth of flow is
  • Less than the flat surface
  • More than the flat surface
  • Same flow depth
  • None of these
Q14 | Erosion is the interaction
  • Erosivity and rainfall intensity
  • Erodibility and land use
  • Erosivity and erodibility
  • None of these
Q15 | The low speed engine runs at speed of
  • 350 rpm
  • Less than 350 rpm
  • More than 350 rpm
  • More than 1000 rpm
Q16 | The detonation of fuel takes place during
  • Combustion
  • Injection
  • Exhaust
  • None of these
Q17 | Turbocharger of an engine is driven by
  • Dynamo
  • PTO shaft
  • Exhaust gas
  • Air
Q18 | In ignition system, magneto is used for
  • Supply of fuel
  • Supply of spark
  • Supply of air fuel mixture
  • Supply of air
Q19 | Of the following, which is the form of precipitation?
  • Rainfall
  • Snowfall
  • Hail
  • All are correct
Q20 | V' pocket (vetch) type disc separator is used for separation
  • Oblong shape material
  • Irregular shape material
  • Round shape material
  • All are correct
Q21 | A tank capacity of rotary type hand duster is about
  • 2.6-4.5 kg
  • 3.6-4.5 kg
  • 4.0-0.5 kg
  • 5.0-8.5 kg
Q22 | Venturi tube is provided in carburet or for
  • Producing low pressure
  • Producing high pressure
  • Both (a) & (b)
  • None of these
Q23 | In airplane sprayer, the tank capacity ranges between
  • 450-1000 liters
  • 450-1500 litres
  • 450-1800 litres
  • 450-2200 litres
Q24 | In attrition mill, the size of food grains is reduced due to
  • Impact and shear
  • Shear and crushing
  • Impact and crushing
  • Impact only
Q25 | In angle bar cylinder type thresher the clearance between cylinder and concave unit at entrance is
  • 7-13 mm
  • 13-19 mm
  • 15-20 mm
  • 20-25 mm