On This Page
This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 8
Q1 | In case of porosity the volume of pores may change
- With volume change of voids
- With volume change of solids
- Without volume change of solids
- All are correct
Q2 | A soil consistency in the characteristics of the soil at various moisture content when influenced by physical force is
- Cohesion
- Adhesion
- Both (a) and (b)
- None of these
Q3 | Unit injector is also known as
- Nozzle
- Atomizer
- Fuel valve
- All are correct
Q4 | Petrol lubrication system generally is used in
- Two-stroke engines
- Four -stroke engines
- Tractor and vehicles
- Aircraft
Q5 | Cold plugs is used on
- Powering engine
- Petrol engine
- Diesel engine
- All are correct
Q6 | Of the following the main parts of syndicator type thresher are
- Corrugated flywheel
- Serrated chopping knives
- Closed cylinder casing
- All are correct
Q7 | When the knife section of cutter bar stops in the center of its guard after every stroke is
- Alignment
- Registration
- Reel index
- Stroke length
Q8 | Wind due to its motion possesses the
- Potential energy
- Kinetic energy
- Chemical energy
- Electrical energy
Q9 | A machine used to cut herbage crops and leave them in swath is
- Reaper
- Mower
- Combine
- Baler
Q10 | The specific gravity of petrol at 15? is
- 0.73
- 0.82
- 0.9
- 0.85
Q11 | The true point of hitch of the implement is called
- Line of pull
- Centre of pull
- Centre of resistance
- All are correct
Q12 | Lubricants are available in the form of
- Fluid
- Semi-fluid
- Semi-solid
- All are correct
Q13 | The seed rate required in broadcasting method in comparison to drilling is
- More
- Less
- Equal
- All are correct
Q14 | The operation to perform to open any cultivable land is
- Primary tillage
- Secondary tillage
- Minimum tillage
- Reduced tillage
Q15 | Specific gravity of a fully charged battery is
- 1.27
- 1.28
- 1.15
- None of these
Q16 | The useful life of self-propelled combine is
- 5 years
- 6 years
- 8 years
- 10 years
Q17 | The output capacity of rotary power scythe depends on
- Field condition
- Physique of operator
- Both (a) & (b)
- None of these
Q18 | Vertical clearance of MB plough influences
- Depth of cut
- Width of cut
- Both depth and width of cut
- None of these
Q19 | The coulter of MB plough is generally mounted
- Above share point
- Little ahead of share point
- Both (a) & (b)
- None of these
Q20 | The four-stroke engines are
- High speed engine
- Low speed engine
- Medium speed engine
- All are correct
Q21 | Specific gravity of petroleum-based hydraulic fluid is
- 0.5
- 0.7
- 0.8
- None of these
Q22 | The internal angle between the gangs of single action disc harrow is
- Less than 90?
- Exactly 90?
- More than 90?
- None of above
Q23 | The immersion method is used for identifying
- Nozzle discharge
- Droplet size
- Spraying pressure
- Spray pattern
Q24 | Spark plug gap setting should be kept between
- 0.50 and 0.85 mm
- 0.5 and 0.90 mm
- 0.50 and 1.00 mm
- 0.50 and 1.20 mm
Q25 | In bucket elevtors, the total stretch of belt under maximum load should not exceed more than
- 1-2 % of belt length
- 1-2.5 % of belt length
- 1-3% of belt length
- 1-3.5% of belt length