Agricultural Engineering Set 19

Other topics

Learning Mode Previous Next
On This Page

This set of Agricultural Engineering Multiple Choice Questions & Answers (MCQs) focuses on Agricultural Engineering Set 19

Q1 | Downstream section of straight drop spillway is called as
Q2 | In thin layer drying, the depth of grain layer should be
Q3 | The term harvesting is associated with
Q4 | A long mould board with gentle curvature used in tough soil full of grasses is
Q5 | The threshing of crop by stripping is done with the help of
Q6 | Bench terracing is also called as
Q7 | The stubble type of mould board is mostly suitable for
Q8 | The depth measured at the centre of the disc by placing its concave side down on a flat surface is
Q9 | Constant speed engine is used in
Q10 | The seed tubes are made of
Q11 | Drying temperature for using batch-bin dyers is
Q12 | Chemically correct air mixture ratio for Otto cycle engine is
Q13 | The rate of doing work is equal to
Q14 | A point at which the resultant of all horizontal and vertical forces acts is
Q15 | Ratio of net pull produced for the dynamic normal load on traction device is called
Q16 | Air injection pumps are mostly used in
Q17 | The viscosity of oil denoted by a number is
Q18 | Gears are generally made of
Q19 | The purpose of harrowing is to
Q20 | The solar cells used in solar panel are used to convert solar energy into
Q21 | The thermal efficiency of diesel engine varies between
Q22 | The press wheel used for compaction of soil around the seeds in high moisture conditions are
Q23 | In wind erosion movement of particle is carried out by
Q24 | Ratio of total force output of the traction device in direction of travel to dynamic weight on traction device is
Q25 | A disadvantage of air-cooling system is
Previous Next