Thermal Engineering II Set 13

Mechanical Engineering

Learning Mode Previous Next
On This Page

This set of Thermal Engineering 2 Multiple Choice Questions & Answers (MCQs) focuses on Thermal Engineering II Set 13

Q1 | The use of which of the following becomes necessary during expansion of steam?
Q2 | What is the specific heat of the ideal working fluid used in vapour power cycle?
Q3 | What is the importance of the freezing point of the working fluid in the vapour power cycle?
Q4 | The engines which are operating on gas power cycle are?
Q5 | Energy recovery is typically via production of __________
Q6 | Which of the following industrial process uses waste as a fuel?
Q7 | What is the combustion temperature range in cement kiln incineration?
Q8 | Non-volatile heavy metals in kiln are fixed into __________
Q9 | Which of the following waste types are not suitable for co-combustion in cement kilns?
Q10 | . Due to the limits, upper efficiency of steam turbines is fixed to _________
Q11 | 5. How many sections does waste heat recovery boiler have in steam generators?
Q12 | Turbines that are run by exhaust gases are called _______
Q13 | Combination of two or more thermodynamic processes gives _________
Q14 | By using combined cycle steam and gas power plant _________
Q15 | What are turbo-compound engines?
Q16 | The mercury steam cycle represents how many coupled Rankine cycles?
Q17 | In the mercury steam cycle, the mercury cycle is called?
Q18 | In the mercury steam cycle, the steam cycle is called?
Q19 | Apart from mercury & steam, which of these is a component of tertiary cycle?
Q20 | The addition of sulphur dioxide in a tertiary cycle is at?
Q21 | Which of these can also be used as a topping fluid?
Q22 | Which of these can be used as a fluid in the bottoming fluid?
Q23 | In case of Sodium-mercury-steam cycle, which is the topping fluid?
Q24 | In case of mercury-steam-sulphur dioxide cycle, which is the bottoming fluid?
Q25 | The total loss in a tertiary cycle is?
Previous Next