Material Handling Set 1

Mechanical Engineering

Learning Mode Next
On This Page

This set of Material Handling Multiple Choice Questions & Answers (MCQs) focuses on Material Handling Set 1

Q1 | Which of the following resistance depends on the train speed?
Q2 | In case of electric traction, power supply frequency for 25 kV single phase system is
Q3 | The number of cylinders in case of steam locomotives is
Q4 | In case of screw conveyors, cut flights are used for
Q5 | Which one of the following shovel excavators is considered most efficient in loading carriers?
Q6 | In screw conveyors, ribbon screws are used for
Q7 | A jack having 2 cm as the diameter of the screw at the root of the thread, may be expected to safely lift a load of about
Q8 | Automatic scales can be used with
Q9 | The angle of repose depends on
Q10 | Car shakers are often used for
Q11 | A four wheel drive has
Q12 | The maximum degree of broad gauge line is
Q13 | In case of flight conveyors the angle of flight is seldom allowed to exceed
Q14 | In case of pneumatic system, a receiver is
Q15 | Flight conveyors are mainly used for conveying
Q16 | A chain link while in use may be subjected to
Q17 | In case of a single girder overhead travelling crane, the section used is
Q18 | The distance between the rails of a metre gauge railway line is
Q19 | Pneumatic conveyors are generally used for conveying
Q20 | Electric motor used for skip hoists may be
Q21 | We know that acid phosphate (damp) adheres to the belt of belt conveyor. Which of the following conveyor will be preferred for conveying this material?
Q22 | In case of an overhead travelling crane, the hoisting unit is supported on
Q23 | Which of the following material has the highest weight/volume ratio?
Q24 | The expected life of a light commercial vehicle is nearly
Q25 | In electric traction, the torque exerted is
Next