Structural Mechanics Set 5

Civil Engineering

Learning Mode Previous Next
On This Page

This set of Structural Mechanics Multiple Choice Questions & Answers (MCQs) focuses on Structural Mechanics Set 5

Q1 | The moment of inertia of a body is always minimum with respect to its
Q2 | Moment of inertia is the
Q3 | In a simply supported beam carrying a uniformly distributed load W/m over the left half span, the point of contra flexure will occur in
Q4 | A sudden increase or decrease in shear force diagram between any twopoints indicates that there is
Q5 | When the bending moment is parabolic curve between two points, it indicates that there is
Q6 | In Fig.(a), max B.M. will be
Q7 | In Fig. (a), slope of S.F.D. between B and C will be
Q8 | What is the bending moment at end supports of a simply supported beam?
Q9 | What is the maximum shear force, when a cantilever beam is loaded withudl throughout?
Q10 | Sagging, the bending moment occurs at the of the beam.
Q11 | What will be the variation in BMD for the diagram? [Assume l = 2m].
Q12 | What is the maximum bending moment for simply supported beam carrying a point load “W” kN at its centre?
Q13 | How do point loads and udl be represented in SFD?
Q14 | curve is formed due to bending of overhanging beams.
Q15 | The relation between slope and maximum bending moment is
Q16 | What is the SF at support B?
Q17 | Where do the maximum BM occurs for the below diagram.
Q18 | Shear force is unbalanced to the left or right of the section.
Q19 | SI units of shear force is
Q20 | Determine the moment at fixed end.
Q21 | Shear force diagram is representation of shear force plotted as ordinate.
Q22 | Hogging is
Q23 | At the point of contraflexure, the value of bending moment is
Q24 | Positive/negative bending moments occur where shear force changes its sign.
Q25 | Shear force of following diagram
Previous Next