On This Page
This set of Heat Engines Multiple Choice Questions & Answers (MCQs) focuses on Heat Engines Set 13
Q1 | Engines are supercharged
- To increase engine durability
- To increase specific power output
- To increase air-fuel ratio
- To improve heat transfer
- To reduce combustion temperature
Q2 | Thermodynamic equilibrium is completely defined by the specifications of the
- Internal energy
- Enthalpy
- Generalized displacements
- All above together
- None of the above
Q3 | Within the boiler the temperature of steam is highest in
- Water drum
- water tubes
- Superheater outlet
- Water walls
- Superheater inlet
Q4 | A closed vessel contains air at 1.2 ata and 57?C. The pressure of air in the vessel if the contents of the vessel are cooled to 37?C would be
- 1.2 ata
- 1.127 ata
- 2.327 ata
- 0.563 ata
- 0.073 ata
Q5 | Which one of the following acts as ignition accelerator for C.I. engines fuel
- Acetone peroxide
- Hydrogen peroxide
- None of above
- n heptane
- Armatic compounds
Q6 | Paraffins in petrol have the general formula
- Cn Hn
- Cn H2n + 2
- Cn H2n - 4
- Cn H2n
- Cn H2n - 2
Q7 | If an air cooled compressor gets over-heated during operation, the probable cause cannot be
- Direction of rotation wrong
- Valve strips broken
- Leadage in intercooler
- Insufficient lubricating oil
- Intake fliter clogged
Q8 | The phenomenon of hunting is associated with
- Governors
- Gears
- Cloth mechanism
- Carburetors
- Tappet valves
Q9 | The term regeneration is closely associated with
- Steam engines
- Steam turbines
- Diesel engines
- Gas engines
- Wankel engines
Q10 | The air standard efficiency of a turbine cycle is 56.5%, which one of the following may be Carnot efficiency between the temperature limits of the cycle?
- 75%
- 64%
- 50%
- 100%
- 56.50%
Q11 | A wankel engine is
- Rotory engine
- Turbine engine
- Jet engine
- Reciprocating engine
- Hybrid engine
Q12 | The temperatures and pressures for boiler are given below. Which of these boilers can be classified as super-critical pressure boiler?
- 250 psi, 150?C
- 100 kg/cm2, 450?C
- 10 kg/cm2, 150?C
- 150 kg/cm2, 500?C
- 218 kg/cm2, 540?C
Q13 | Motor cycle not using deflector type piston usually utilise
- Reverse flow scavanging
- Ideal scavanging
- Uniflow scavanging
- Natural scavanging
- Loop scavanging
Q14 | Direction of feed water is done because
- It reduces weight of water to be handled
- It reduced priming difficulties in feed pumps
- It reduces corrosion caused by oxygen present in air
- It reduces amount of heat required to convert water into steam
- None of the above
Q15 | The dryness fraction of steam within a turbine is usually not allowed to fali below
- Unity
- 0.45
- 0.8
- 0.9
- 0.99
Q16 | Which of the following is an accessory for a boiler?
- Stop valve
- Feed check valve
- Safety valve
- Feed pump
- Blow off cock
Q17 | The molecules move in a solid
- At random
- Back and forth like tiny pendulum
- In irregular motion
- In circular motion
- None of above
Q18 | In all a four stroke four cylinder engine will have how many valves?
- 8
- 16
- none
- 4
- Carbon dioxide
Q19 | Latent heat is
- Heat required to change the state or condition under which the substance exists
- Heat that does not follow first law of thermodynamics
- Heat required to change the state of substance from liquid state to solid state
- Heat required to change the substance from solid to gaseous state
- Heat cannot be detected
Q20 | Steam consumption per kWh of electricity generated in a modern power plant is of the order of
- 10 -12 kgs
- 5 - 7 kgs
- 8 - 10 kgs
- 2 - 4 kgs
- 1 - 2 kgs
Q21 | In jet engines the compression ratio
- Varies with square of speed
- Remains constant
- Varies with altitude
- Depends on other factors
- Varies with altitude
Q22 | An Orsat's apparatus is used for
- None of above
- Gravimetric analysis of the flue gases
- Volumetric analysis of the flue gas
- Smoke density analysis of the flue gases
- All of above
Q23 | Motoring test on I.C. engines is conducted to measure
- I.H.P.
- B.H.P.
- Pumping horse power
- Friction horse power
- None of the above
Q24 | The turbidity in boiler feed water causes
- Sludge
- Scale
- Corrosion
- Embrittlement
- None of the above
Q25 | Steam leaves the steam nozzle at
- Low pressure and low velocity
- Low pressure and high velocity
- High pressure and low velocity
- High pressure and high velocity
- None of the above