8086 Microprocessor Set 2
On This Page
This set of 8086 Microprocessor Multiple Choice Questions & Answers (MCQs) focuses on 8086 Microprocessor Set 2
Q1 | The push source copies a word from source to ______
- stack
- memory
- register
- destination
Q2 | LDs copies to consecutive words from memory to register and ___________
- es
- ds
- ss
- cs
Q3 | INC destination increments the content of destination by _______
- 1
- 2
- 30
- 41
Q4 | IMUL source is a signed _________
- multiplication
- addition
- subtraction
- division
Q5 | _________destination inverts each bit of destination
- not
- nor
- and
- or
Q6 | The JS is called as ______
- jump the signed bit
- jump single bit
- jump simple bit
- jump signal it
Q7 | Instruction providing both segment base and offset address are called _____
- below type .
- far type
- low type
- high type
Q8 | The conditional branch instruction specify ___________ for branching
- conditions
- instruction
- address
- memory
Q9 | ______
- carry flag
- conditional flag
- common flag
- sign flag
Q10 | The LES copies to words from memory to register and __________
- ds
- cs
- es
- ds
Q11 | The _________ translates a byte from one code to another code
- xlat
- xchng
- pop
- push
Q12 | The _______ contains an offset instead of actual address
- sp
- ip
- es
- ss
Q13 | The 8086 fetches instruction one after another from __________ of memory
- code segment
- ip
- es
- ss
Q14 | The BIU contains FIFO register of size 6 bytes called _____.
- queue
- stack
- segment
- register
Q15 | Signal
- ur signal
- vcc
- aie
- ground
Q16 | The pin of minimum mode AD0-AD15 has ____________ address
- 16 bit
- 20 bit
- 32 bit
- 4 bit
Q17 | The pin of minimum mode AD0- AD15 has _________ data bus
- 4 bit
- 20 bit
- 16 bit
- 32 bit
Q18 | The address bits are sent out on lines through __________
- a16-19
- a0-17
- d0-d17
- c0-c17
Q19 | ________ is used to write into memory
- rd
- wr
- rd / wr
- clk
Q20 | The functions of Pins from 24 to 31 depend on the mode in which _______ is operating
- 8085
- 8086
- 80835
- 80845
Q21 | The RD, WR, M/IO is the heart of control for a __________ mode
- minimum
- maximum
- compatibility mode
- control mode
Q22 | In a minimum mode there is a ___________ on the system bus
- single
- double
- multiple
- triple
Q23 | If MN/MX is low the 8086 operates in __________ mode
- minimum
- maximum
- both (a) and (b)
- medium
Q24 | In max mode, control bus signal So,S1 and S2 are sent out in ____________ form
- decoded
- encoded
- shared
- unshared
Q25 | The ___ bus controller device decodes the signals to produce the control bus signal
- internal
- data
- external
- address