Breakdown
___________ maintenance is the least sophisticated maintenance work and normally is used only on equipment that is inexpensive and noncritical to plant operations.
Corrective
_________ Work is requested, discovered during periodic inspections, or discovered while performing other maintenance tasks.
Logbook
A(n) _________ is a book or electronic file that documents all work performed during a shift and lists information needed to complete work by maintenance technicians on other shifts.
Offset
Misalignment is a condition where two shafts are parallel but are not on the same axis.
Soft foot
_________ is a condition that occurs when one or more machine feet do not make complete contact with a base plate.
Motor
The _________ is normally the machine to be shimmed (MTBS).
Plain
_________ bearings are quieter, less costly, and if kept lubricated, have little metal fatigue compared to other bearings.
Replaced
Any worn spacers, shafts, bearings, or housings must be ________.
Glazed
A ___________ belt has reduced friction with the pulleys, resulting in belt slippage and a loss of power transmission.
Angular
__________ misalignment is corrected using a level placed on top of the pulley, parallel with the pulley shaft.
Deflection
During retensioning, the __________ height from the normal position is determined by the use of a straightedge or string stretched across the pulley tops.
Hipot testers
Tests using ____________ normally involve applying a test voltage that is several times higher than the specified operating voltage of the cable or device being tested.
Insulation spot
A(n) __________ test is a test that checks motor insulation over the life of the motor.
Run-in
A machine __________ check should be made after bearing assembly is complete.
Polarization
A low ___________ index indicates excessive moisture or contamination.