Chapter 3: Fire Department Communications

Which of the following is a telecommunications system?

Public Safety Answering Point (PSAP)

Which of the following is a type of communications center equipment?

Two-way radio systems

Which of the following standards has the minimum requirements for receiving, processing, and dispatching emergency responders?

NFPA 1221

Which of the following is a type of public alerting system?

Wired telegraph circuit box

Which of the following would be considered a nonemergency call?

An appointment reminder

Who is the contact person for nonemergency calls?

Public Information Officer (PIO)

Which of the following BEST describes the action first taken after an alert to the station?

Recording of incident information

Which of the following methods may be used to confirm a dispatch transmission?

Keying the radio microphone

What communication category is defined as messages transmitted within the fire department?

Internal communications

Which of the following types of general knowledge is required for internal communications?

How a radio system works

Which of the following have stable, powerful transmitters and interference-resistant receivers?

Base station radios

Which of the following travels between the transmitter and receiver in either analog or digital format?

Radio signal

Which of the following is a repeater system that uses two radio frequencies for communications?

Half-duplex

Which of the following has a radio frequency that is dedicated to a single functions?

Conventional system

Which of the following regulates all radio communication in the United States?

Federal Communications Commission (FCC)

The use of ten-codes in radio transmissions was replaced when agencies began to adopt which of the following?

National Incident Management System (NIMS)

Which of the following radio limitations can mean a receiver is near the limit of its transmission range?

Static and broken messages

Which of the following is designed by radio manufacturers to filter out interference?

Electric motors

Which of the following is an example of how to avoid ambient noise?

Moving out of the wind

Units or individuals must ___ in every transmission as outlined in the local radio protocols.

Identify themselves

Which of the following is the MOST accurate rule to control communications?

Receiver must acknowledge every message by repeating essence of the message to sender

Which of the following is a guideline to ensure a message is heard and understood?

Use a moderate rate of speaking

Which of the following is a radio communications best practice?

Speak with a loud, controlled, clear voice